Ceramic imitation stone PC brick, also known as ceramic imitation stone brick or ceramic granite, is a type of ceramic product that imitates the surface texture of granite. It is specifically used for outdoor municipal engineering, garden landscape engineering, etc. Many users are concerned about the color difference of ceramic imitation stone PC brick, which may affect the overall construction quality and usage effect of the project. In fact, for manufacturers, there will be color differences in each batch of bricks. As long as they are controlled within a reasonable range, the existence of color differences does not affect their quality, so there is no need to worry too much. So below, the editor will explain what causes color difference, so that everyone can have a clearer understanding that the existence of color difference does not affect product quality.
1. Firing temperature: When the body of the ceramic imitation stone PC brick is heated to 400-500 ℃, the clay minerals begin to oxidize and decompose, and the Fe2O3 in the brick begins to color, gradually turning red from earthy color. As the temperature increases, the red color deepens, and when the temperature rises to 900-1000 ℃, it turns brownish red.
2. Salt minerals: At the firing temperature, limestone in ceramic imitation stone PC bricks will decompose into white CaO, which has a certain bleaching effect on the bricks. When the ratio of CAO to Fe2O3 content is greater than 4, the bricks will appear white; As the ratio decreases until trace amounts of CaO are present, the color gradually changes from cream to yellow and brownish red.

3. Kiln height: Due to the presence of kiln height, the upward force of hot gas causes a certain temperature difference between the upper and lower parts of the kiln section. The higher the kiln, the greater the temperature difference between the upper and lower parts. The upper part of the kiln has a higher temperature, and the color of the ceramic imitation stone PC brick is darker, while the lower part has a lower temperature, resulting in a relatively lighter color.
4. It is impossible to evenly distribute external coal to various parts of the billet stack. The coal ash generated by external coal can bury individual billet heads under the stack, which may result in black bricks due to oxygen deficiency. In addition, the unevenness of the code billet results in certain differences in the atmosphere of each part of the billet stack, so the bricks in different parts of the kiln will exhibit certain color differences.
5. Kiln structure: Poor insulation in a certain part of the kiln, or inadequate sealing and air leakage, may cause uneven temperature and atmosphere changes in these parts of the kiln, resulting in color differences.
So overall, the Fe2O3 content is the main internal factor affecting the color of ceramic imitation stone PC bricks, and the firing furnace is the main external factor affecting its color difference. However, this only causes a certain color difference in the product, and its material has not changed in any way. Therefore, when purchasing this product, if you see that its surface color is not exactly the same, you can rest assured that its effectiveness is still the same.